ADS FlexStorm Pure Submittal Drawing

Filename:
ADS FlexStorm Pure Submittal Drawing.pdf

ADS FlexStorm Pure Submittal Drawing

This document is the ADS FlexStorm Pure Submittal Drawing. The ADS unit figures with supporting tables and notes provided.

The ADS FlexStorm Pure inlet filters are shown. The round inlet filter diagram is shown with table detailing the values for clear opening size, style P/N and minimum bypass flow rate.

The curb open throat inlet filter diagram is shown with a table detailing the values for basin width size and style P/N.

The square/rectangular inlet filter diagram is shown. The table below shows the values for clear opening size, style P/N and minimum bypass flow rate.

A chart with specifications by nominal size range shows the values for nominal bag size, solids storage, flow rate and oil retention.

A figure shows the entire unit with installation instructions to remove grate, clean grate ledge, set inlet filter on load bearing ledge of structure and replace grate.

Notes state that all framing is constructed of 304 stainless steel. Total bypass capacity will vary with each size drainage structure. Confirmation of the inlet specification, precast/foundry casting make and model or detailed dimensional forms must be proved to configure and assemble inlet filter. All filters meet ASTM D8057 specifications.

Looking for something else?

View Document Library
Microsoft will be phasing out Internet Explorer soon. Because of this, we did not build the site to be used with IE. Please use Chrome, Edge or another browser to fully experience the new ADS website. .